After the standing water is gone, the building is still wet. Structural drying uses air movers and dehumidifiers to pull moisture from floors, walls and ceilings until readings reach the dry reference.
(888) 450-9281Start the Dana Point structural drying
Make sure the leak or flood has been stopped before drying equipment goes in.
Keep air movers and dehumidifiers running, and do not move or switch them off.
Close doors and windows in the drying area so the dehumidifier works at full strength.
Let the tech in each day, and keep the daily log for your insurer.
Extraction takes off the standing water, but wood, drywall and concrete keep holding moisture inside. Structural drying is the controlled removal of that water, using airflow, heat and dehumidification, so the building returns to its normal moisture content instead of drying unevenly on its own.
Drying is a measured process, not a matter of leaving fans on. Equipment is sized to the room, the materials and the class of loss.
Structural drying in a Dana Point home usually costs $1,400 to $12,000. Water class, the number of wet rooms and how dense the wet materials are decide the figure, with desiccant or floor mats adding to dense jobs.
Ranges are typical figures, not a quote. The category of water, the square footage, the material class and how fast drying started move the number most. The water damage cost calculator gives a closer range.
The tech who does the walkthrough finds the source and maps the moisture before equipment goes down, and the drying team keeps it running until the readings say dry.
Meters, a thermal camera and room measurements set the class of loss and the equipment count.
Air movers, LGR dehumidifiers and any desiccant units go in, with the room closed.
Each day the tech takes meter and air readings and moves equipment where needed.
Equipment comes out when every material matches the dry reference.
Class 1 involves little wet material, Class 2 a whole room of carpet and wall bottoms, Class 3 water from above that soaked ceilings and insulation, and Class 4 dense materials such as hardwood and concrete.
Most jobs begin with water extraction, and burst pipe water damage shows how the two fit together.
The tech compares meter readings in each wet material against a dry reference taken from unaffected rooms. When every reading is at or near that reference, the drying goal is met, and the equipment comes out.
Daily logs record temperature, humidity and readings, which gives an adjuster proof that drying was done properly. Equipment is adjusted each day, and nothing is picked up on a guess.
Structural drying crews cover ZIP 92629 and 92624, including the Lantern District, Capistrano Beach, Monarch Beach, Monarch Bay, Niguel Shores, Ritz Pointe and the homes around Dana Point Harbor.
The same service nearby: structural drying and dehumidification in Laguna Niguel, San Juan Capistrano, Laguna Beach.
Wood, drywall and concrete hold water that extraction cannot reach. Without drying it stays inside and keeps causing damage.
Household fans and units move far less air and water than restoration equipment, and they cannot show the moisture inside walls.
Air movers and dehumidifiers run steadily and are noticeable, since they work around the clock until the readings are met.
It is the moisture reading of the same material in an unaffected part of the building, and drying is complete when the wet material matches it.
Not always. Most homes stay occupied during drying, though some rooms are closed off while equipment runs.
Daily visits check readings, adjust equipment and log progress. Those records show an insurer that the drying was done correctly.
Walls or floors still damp in Dana Point? The drying team works 24/7.
Extraction removes the standing water; drying removes the rest. The Dana Point team runs equipment until every reading is at goal.
(888) 450-9281Book Dana Point structural drying